Rheem · ProTerra 120V plug-in
Rheem ProTerra 120V plug-in error code A123
Shut-Off Valve Not Installed
What it means
Shut-Off Valve malfunction
Also listed in: Residential 120V Plugin With HydroBoost Heat Pump Water Heater (Shared Circuit) Use & Care Manual, AP22654 Rev 01, page 31
What Rheem says to do
These steps involve electrical testing or parts replacement. Rheem's manuals tell owners to leave that work to a qualified service technician.
1. Check connections of the wiring. 2. Unplug and plug back the Shut-Off valve. 3. If alarm persist, call customer service.
Last checked 2026-10-03.
Safety first
- CAUTION: For your safety DO NOT attempt repair of electrical wiring, thermostats, or other safety devices. Refer repairs to qualified service personnel. (p.28)
- WARNING: If the water heater has been subjected to fire, flood or physical damage, disconnect all power to water heater, and DO NOT operate the water heater again until it has been checked by a qualified service technician. (p.19)
From the manufacturer's manual for this series.
The same code on other models
Codes mean different things on different heaters. Match the series to the model number on your rating label.
Other ProTerra 120V plug-in codes
- A004 (Comp.Shutdown: Discharge-Suction Trip)
- A005 (Compressor Shutdown: Discharge Temp High)
- T005 (Compressor Shutdown: Discharge Temp High)
- A006 (Suction Temperature Too Low)
- T006 (Suction Temperature Too Low)
- T009 (Compressor wiring may be faulty)
- A009 (Compressor wiring may be faulty)
- A101 (Suction Temperature Sensor Failure)
- A102 (Ambient Temperature Sensor Failure)
- A103 (Lower Heater Temp Sensor Failure)
- A104 (Upper Heater Temp Sensor Failure)
- A105 (Evaporator Temp Sensor Failure)
- A106 (Discharge Temp Sensor Failure)
- A107 (Water Detected on Floor: Check For Leaks)
- A108 (Condensate Blocked: Unclog Line)
- A130 (Unit Off/Air Temp Freezing: Enable Unit)
- T131 (Clean Filter Reminder)
- T132 (Water Heater difficulty satisfying demand)
- A120 (Shutoff Valve Can't Close Error)
- A121 (Shutoff Valve Can't Open Error)
- A122 (Shutoff Valve Inputs in Error)
- A200 (High Water Temp! [ECO] Call Tech Service)
- T300 (Water vor Not Installed [sic; as printed])
- A502 (Time Clock needs to be programmed)
- A503 (Time Clock not advancing time properly)
- T504 (WiFi Chip Communication Error)
- A900 (Controller Fault: Call Tech Service)
- T901 (Controller Fault: Call Tech Service)
- A902 (Controller Fault: Call Tech Service)
- A903 (Controller Fault: Call Tech Service)
- A904 (Controller Fault: Call Tech Service)
- A905 (Controller Fault: Call Tech Service)
- A906 (Power Board Temp. Protection Sensor Failure)